How to Replace a Stabilizer Link in a VW Passat

Volkswagen Passat bridges the gap between the run-of-the-mill mid-size auto and the often out-of-reach luxury brands. The Passat is both classy and restrained inside and out while offering a quiet, refined drive with great performance and easy handling. The following steps guide you through the do-it-yourself installation of a new stabilizer and links..#

Make sure the vehicle is completely cool. Disconnect the battery ground and then isolate it avoid accidental contact with the terminal during this procedure.
#
Step 2

Put the vehicle on a rack or raise the front of the vehicle on supports. Verify the security of the supports. Remove the front wheels and tires.
#
Step 3

Loosen the fasteners that hold the ends of the sway bar. Remove the nuts and bolts from the brackets.
#
Step 4

Take the stabilizer (sway) bar from the vehicle. Be careful that no proximate cables get caught on the bar.
Install the Stabilizer Bar and Links
#
Step 1

Set the new stabilizer bar in place. Finger-tighten the bolts to the brackets.
#
Step 2

Install the fasteners to the outer ends of the stabilizer bar. Tighten the nuts by hand. Be sure to position the washer collars away from the bushings with the cone-shaped side of the bushings is oriented toward the washers.
#
Step 3

Install the front wheels. Lower the vehicle and bounce it several times to allow it to stabilize.
#
Step 4

Torque the nuts to 15 foot pounds. Connect the negative battery cable to the terminal. Test drive the vehicle to verify proper steering and handling.